Protocol analysis
R&S
®
RTP
714User Manual 1337.9952.02 ─ 12
13.13.5.2 D-PHY search results
To get search results, "Enable" the search. You can minimize, shift or close the search
dialog.
The search results are listed in the search result table and marked in the waveform by
blue lines.
For an introduction to search results, see:
●
Chapter 11.1.2, "Search results", on page 449
●
Chapter 11.4.2, "Display zoom settings", on page 468
Remote commands:
●
SEARch:RESult:DPHY:FCOunt? on page 1869
●
SEARch:RESult:DPHY:FRAMe<m>:CS? on page 1869
●
SEARch:RESult:DPHY:FRAMe<m>:DATA? on page 1870
●
SEARch:RESult:DPHY:FRAMe<m>:DTName? on page 1870
●
SEARch:RESult:DPHY:FRAMe<m>:DTYPe? on page 1870
●
SEARch:RESult:DPHY:FRAMe<m>:ECC? on page 1871
●
SEARch:RESult:DPHY:FRAMe<m>:PACKet<n>:IDX? on page 1871
●
SEARch:RESult:DPHY:FRAMe<m>:PACKet<n>:VALue? on page 1871
●
SEARch:RESult:DPHY:FRAMe<m>:STARt? on page 1872
●
SEARch:RESult:DPHY:FRAMe<m>:STATe? on page 1872
●
SEARch:RESult:DPHY:FRAMe<m>:STOP? on page 1872
●
SEARch:RESult:DPHY:FRAMe<m>:TYPE? on page 1873
●
SEARch:RESult:DPHY:FRAMe<m>:VCHannel? on page 1873
13.13.5.3 Searching D-PHY
Prerequisite: A serial bus is configured for the D-PHY signal to be decoded and ana-
lyzed.
The search for events is set up in the following way:
1. Press [Search] or tap "Search" > "Setup" in the menu bar.
2. If the dialog box does not contain a search entry, tap the "Add" icon to create one,
as described in "To create a user-defined search" on page 463.
3. Tap "Source" and select the serial bus that is set to D-PHY (e.g. "SB1", unless
already selected).
4. Specify search criteria according to Chapter 13.13.5.1, "D-PHY search setup",
on page 711.
5. To acquire a waveform, press [Single].
The R&S RTP performs a D-PHY decode according to the thresholds and protocol
settings of the associated serial bus source.
D-PHY (ption R&S
RTP-K42)
To Next Page
Loading...
