Protocol analysis
R&S
®
RTP
717User Manual 1337.9952.02 ─ 12
Make sure that the tab of the correct serial bus is selected.
See also: Chapter 13.1.1, "Setup - general settings", on page 512
Variant
Selects the protocol running on the interface. You can select between the M-PHY, Uni-
Pro and SSIC.
Remote command:
BUS<m>:MPHY:VARiant on page 1874
Lanes
Sets the number of logical lanes that are mapped to the physical lines. You can select
up to four lanes.
Remote command:
BUS<m>:MPHY:DLANes on page 1874
Lane 0 / Lane 1 / Lane 2 / Lane 3: Channel
Select the signal sources for the logical lanes.
Remote command:
BUS<m>:MPHY:DZERo:SOURce on page 1875
BUS<m>:MPHY:DONE:SOURce on page 1875
M-PHY and USB SSIC (option R&S
RTP-K44 and K64)
To Next Page
Loading...
