Protocol analysis
R&S
®
RTP
741User Manual 1337.9952.02 ─ 12
"Data Min/Data"
Defines the bit pattern of the PACP Function ID pattern.
In binary format, use the following characters: 1; 0; or X (do not care).
To enter the pattern in other formats use the bit pattern editor, see
Chapter 13.1.7, "Bit pattern editor", on page 519.
"Data Max"
The second PACP Function ID pattern is required to specify a range
with conditions "In range" and "Out of range".
Remote command:
SEARch:TRIGger:MPHY:PFID:CONDition on page 1913
SEARch:TRIGger:MPHY:PFID:MIN on page 1913
SEARch:TRIGger:MPHY:PFID:MAX on page 1913
Errors
Sets the type of error events to be searched for.
Reserved Bit Error ← Errors
Searches for reserved bit error.
This error means that the waveform violates the reserved field according to the specifi-
cation. For example, a DL_PDU_AFC frame requires that the two bits before and three
bits after the FSN field to be reserved and set as 0. If the waveform carries 1 in these
positions instead, it is marked as this error.
Remote command:
SEARch:TRIGger:MPHY:ERRor:REServed on page 1914
LCC Command Error ← Errors
Searches for LCC command error.
This error is marked when the Command field in the LCC packet is not a known com-
mand defined in the specification.
Remote command:
SEARch:TRIGger:MPHY:ERRor:LCMD on page 1914
8b10b Symbol Error ← Errors
Searches for 8b10b symbol error.
For example, some of the 10-bit combinations that do not map to 8-bit according to the
specification are invalid 10-bit and therefore marked as this error.
Remote command:
SEARch:TRIGger:MPHY:ERRor:SYMBol on page 1914
Unknown Unipro Frame ← Errors
Searches for unidentified UniPro frame error. This error is marked when the end mark
on Unipro packets is undetected.
Remote command:
SEARch:TRIGger:MPHY:ERRor:UNKNown on page 1914
Length Error ← Errors
Searches for frames that violate the length according to the specification.
M-PHY and USB SSIC (option R&S
RTP-K44 and K64)
To Next Page
Loading...
