Rohde & Schwarz RTP044 - Page 786

Protocol analysis
R&S
®
RTP
786User Manual 1337.9952.02 ─ 12
Disparity error
Searches for disparity errors.
Remote command:
SEARch:TRIGger:EBTB:DISParityerr on page 1984
Glitching error
Searches for glitching errors.
Remote command:
SEARch:TRIGger:EBTB:GLITcherror on page 1985
Unknown symbol error
Searches for a symbol that is not defined by the the 8b/10b.
Remote command:
SEARch:TRIGger:EBTB:UNK on page 1987
8b Pattern
Sets the 8-bit pattern to be searched for, if "Type" > "8-bit".
Remote command:
SEARch:TRIGger:EBTB:EBPA on page 1985
10b Pattern
Sets the 10-bit pattern to be searched for, if "Type" > "10-bit".
Remote command:
SEARch:TRIGger:EBTB:TBPA on page 1986
Expression
Defines the expression to be searched for, if "Type" > "Expression".
Remote command:
SEARch:TRIGger:EBTB:SYME on page 1986
13.16.5.2 8b/10b search results
To get search results, "Enable" the search. You can minimize, shift or close the search
dialog.
The search results are listed in the search result table and marked in the waveform by
blue lines.
For an introduction to search results, see:
●
Chapter 11.1.2, "Search results", on page 449
●
Chapter 11.4.2, "Display zoom settings", on page 468
Remote Commands:
●
SEARch:RESult:EBTB:SCOunt? on page 1987
●
SEARch:RESult:EBTB:SYMBol<m>:DATA? on page 1988
●
SEARch:RESult:EBTB:SYMBol<m>:STARt? on page 1988
●
SEARch:RESult:EBTB:SYMBol<m>:STATus? on page 1988
8b/10b (option R&S
RTP-K52)