Protocol analysis
R&S
®
RTP
878User Manual 1337.9952.02 ─ 12
Couple thresholds ← Thresholds
Enables the same threshold value for all lanes.
Find thresholds ← Thresholds
Executes the measurement of reference levels and sets the thresholds to the middle
reference level of the measured amplitude.
Remote command:
BUS<m>:SETReflevels on page 1548
Low threshold ← Thresholds
Sets the lower threshold value for the respective lane.
Remote command:
BUS<m>:PCIE:LONE:THRLow on page 2125
BUS<m>:PCIE:LTHRee:THRLow on page 2125
BUS<m>:PCIE:LTWO:THRLow on page 2125
BUS<m>:PCIE:LZER:THRLow on page 2125
High threshold ← Thresholds
Sets the high threshold value for the respective lane.
Remote command:
BUS<m>:PCIE:LONE:THRHigh on page 2125
BUS<m>:PCIE:LTHRee:THRHigh on page 2125
BUS<m>:PCIE:LTWO:THRHigh on page 2125
BUS<m>:PCIE:LZER:THRHigh on page 2125
13.22.2.2 Display settings
Access: [Protocol] > "Display" tab.
For common display settings, see Chapter 13.1.3, "Display", on page 514.
PCIe (option R&S RTP-K72/K73)
To Next Page
Loading...
