Mixed signal option (MSO, R&S RTP-B1)
R&S
®
RTP
929User Manual 1337.9952.02 ─ 12
Remote command:
BUS<m>:PARallel:THCoupling on page 2202 (all buses)
DIGital<m>:THCoupling on page 2198 (bus1)
Hysteresis ← Advanced
Defines the size of the hysteresis for the respective channels.
"Normal"
The instrument sets a small value suitable for the signal and its set-
tings. Use this setting for clean signals.
"Maximum"
The instrument sets the maximum value that is possible and useful
for the signal and its settings. Use this setting for noisy signals.
"Robust"
Sets different hysteresis values for falling and rising edges to avoid
an undefined state of the trigger system. Use this setting for very
noisy signals.
Remote command:
BUS<m>:PARallel:HYSTeresis<n> on page 2202 (all buses)
DIGital<m>:HYSTeresis on page 2198 (bus1)
Activate channels
Selects the state of the respective bus channel.
Enable/Disable D7-D0, D15-D18
The buttons select or deselect all digital channels of a pod at once.
14.1.1.2 Bus
Access: "Menu" > "Logic" > "Bus" tab
Digital channels and parallel buses
To Next Page
Loading...
