Pulse source and TDR/TDT analysis (option R&S RTP-B7/K130)
R&S
®
RTP
993User Manual 1337.9952.02 ─ 12
Remote command:
TDRT:TYPE on page 2244
Configuration
Selects the connection: "single-ended" or "differential" measurement.
Remote command:
TDRT:CONFig on page 2244
Calibrate setup
Starts the wizard for manual calibration. In the next steps, you connect several calibra-
tion standards and measure the correction parameters.
Measure with default values
Starts the measurement with default correction values instead of calibrating the setup.
Default values are rough values without time reference.
Remote command:
TDRT:DEFault on page 2243
Open
Opens a saved calibration file of a previous calibration and starts the measurement.
Remote command:
TDRT:CALibration:OPEN:NAME on page 2243
TDRT:CALibration:OPEN[:EXECute] on page 2244
16.2.3.2 Setup: channels
Access: [App Cockpit]> "Analysis" > "TDR / TDT" > "Calibrate setup"
TDR/TDT analysis (option R&S RTP-K130)
To Next Page
Loading...
