Ruijie RG-S29 Series

Configuration Guide 802.1X Commands
Since single-host only supports the single-user form, setting default-user-limit on the port manually
does not take effect in single-host mode. If you set default-user-limit on the port after setting
single-host, only one user can be permitted to use the network still.
Configuration
Examples
The following example sets the port to participate in authentication and enable port-based
authentication.
Ruijie(config-if-GigabitEthernet 0/0)# dot1x port-control-mode port-based
Related
Commands
Command
Description
show dot1x port-control
Displays the port control mode.
show running-config
Displays the configuration.
Platform
Description
N/A
4.36 dot1x private-supplicant-only
Use this command to filter non-Ruijie clients.
Use the no form of this command to restore the default setting.
dot1x private-supplicant-only
no dot1x private-supplicant-only
Parameter
Description
Parameter
Description
N/A
N/A
Defaults
This function disabled by default.
Command
Mode
Global configuration mode
Usage Guide
This command is used for authentication supporting only Ruijie clients.
Configuration
Examples
The following example filters non-Ruijie clients.
Ruijie(config)# dot1x private-supplicant-only
Related
Commands
Command
Description
show dot1x private-supplicant-only
Displays the information about the private supplicant.
Platform
Description
N/A