Ruijie RG-S29 Series - Page 1088

Configuration Guide SCC Commands
Common
Errors
N/A
Platforms
N/A
6.3 nac-author-user maxinum
Use this command to configure the limit on IPv4 user capacity on a port.
nac-author-user maxinum max-user-num
Use this command to remove the limit on the IPv4 user capacity on a port.
no nac-author-user maxinum
Parameter
Description
Parameter
Description
max-user-num
Defines the maximum number of IPv4 access users. The range is from
1 to 1,024.
Defaults
By default, the number of IPv4 access users is not limited.
Command
Mode
Interface configuration mode
Default Level
14
Usage Guide
Use this command to configure the maximum number of IPv4 access users on a port.
Configuration
Examples
The following example restricts the maximum number of IPv4 users to 100 on interface Gi 0/1.
Ruijie(config)#int gigabitEthernet 0/1
Ruijie(config-if-GigabitEthernet 0/1)#nac-author-user maxinum 100
Verification
1. Use the show nac-author-user command to display the current and the maximum numbers of IPv4
access users on all ports.
2. Use the show nac-author-user interface interface-name command to display the current and the
maximum numbers of IPv4 access users on the specified port.
Prompt
Messages
N/A
Common
Errors
N/A
Platforms
N/A