Configuration Guide NFPP Commands
21.2 arp-guard enable
Use this command to enable the anti-ARP guard function globally.
Use the no or default form of this command to restore the default setting.
This function is enabled by default.
The following example enables the anti-ARP guard function globally.
Ruijie(config)# nfpp
Ruijie(config-nfpp)# arp-guard enable
Enables the anti-ARP attack on the interface.
show nfpp arp-guard summary
Displays the configuration.
21.3 arp-guard isolate-period
Use this command to set the arp-guard isolate time globally.
Use the no or default form of this command to restore the default setting.
arp-guard isolate-period { seconds | permanent }
no arp-guard isolate-period
default arp-guard isolate-period
Sets the isolate time. The value is 0, or in the range from 30 to 86400
in the unit of seconds.
To Next Page
Loading...
