Ruijie RG-S29 Series

Configuration Guide NFPP Commands
permanent
Permanent isolation.
Defaults
The default isolate time is 0, which means no isolation.
Command
Mode
NFPP configuration mode.
Usage Guide
N/A
Configuration
Examples
The following example sets the arp-guard isolate time globally to 180 seconds.
Ruijie(config)# nfpp
Ruijie(config-nfpp)# arp-guard isolate-period 180
Related
Commands
Command
Description
nfpp arp-guard isolate-period
Sets the isolate time on the interface.
show nfpp arp-guard summary
Displays the configuration.
Platform
Description
N/A
21.4 arp-guard isolate-forwarding enable
Use this command to enable packet forwarding through NFPP isolation.
Use the no form of this command to disable this function.
Use the default form of this command to restore the default setting.
arp-guard isolate-forwarding enable
no arp-guard isolate-forwarding enable
default arp-guard isolate-forwarding enable
Parameter
Description
Parameter
Description
N/A
N/A
Defaults
This function is enabled by default.
Command
Mode
NFPP configuration mode
Usage Guide
N/A
Configuration
Examples
The following example enables packet forwarding through NFPP isolation.
Ruijie(config)# nfpp
Ruijie(config-nfpp)# arp-guard isolate-forwarding enable