Configuration Guide NFPP Commands
21.5 arp-guard monitored-host-limit
Use this command to set the maximum monitored host number.
Use the no or default form of this command to restore the default setting.
arp-guard monitored-host-limit number
no arp-guard monitored-host-limit
default arp-guard monitored-host-limit
The maximum monitored host number, in the range from 1 to
4,294,967,295.
If the monitored host number has reached the default 20,000, the administrator shall set the
max-number smaller than 20,000 and it will prompt the message that %ERROR: The value that you
configured is smaller than current monitored hosts 20,000, please clear a part of monitored hosts to
remind the administrator of the invalid configuration and removing the monitored hosts.
When the maximum monitored host number has been exceeded, it prompts the message that %
NFPP_ARP_GUARD-4-SESSION_LIMIT: Attempt to exceed limit of 20000 monitored hosts to
remind the administrator.
The following example sets the maximum monitored host number to 200.
Ruijie(config)# nfpp
Ruijie(config-nfpp)# arp-guard monitored-host-limit 200
show nfpp arp-guard summary
Displays the configuration.
To Next Page
Loading...
