Configuration Guide NFPP Commands
21.6 arp-guard monitor-period
Use this command to configure the arp guard monitor time.
Use the no or default form of this command to restore the default setting.
arp guard monitor-period seconds
no arp-guard monitor-period
default arp-guard monitor-period
Sets the monitor time, in the range from 180 to 86,400 in the unit of
seconds.
When the attacker is detected, if the isolate period is 0, the attacker will be monitored by the software
and the timeout time will be the monitor period. During the software monitoring, if the isolate period is
not 0, the software-monitored attacker will be auto-isolated by the hardware and the timeout time will
be the isolate period. The monitor period is valid with the isolate period 0.
If the isolate period has changed to be 0, the attackers on the interface will be removed rather than
being monitored by the software.
The following example sets the arp guard monitor time to 180 seconds.
Ruijie(config)# nfpp
Ruijie(config-nfpp)# arp-guard monitor-period 180
show nfpp arp-guard summary
Displays the configuration.
show nfpp arp-guard hosts
Displays the monitored host list.
clear nfpp arp-guard hosts
Clears the isolated host.
21.7 arp-guard rate-limit
Use this command to set the arp guard rate limit.
Use the no or default form of this command to restore the default setting.
arp-guard rate-limit { per-src-ip | per-src-mac | per-port } pps
To Next Page
Loading...
