Ruijie RG-S29 Series

Configuration Guide NFPP Commands
Defaults
This function is enabled by default.
Command
Mode
NFPP configuration mode
Usage Guide
N/A
Configuration
Examples
The following example sets the port based arp guard rate limit.
Ruijie(config)# nfpp
Ruijie(config-nfpp)# arp-guard ratelimit-forwarding enable
Related
Commands
Command
Description
N/A
N/A
Platform
Description
N/A
21.9 arp-guard scan-threshold
Use this command to set the global scan threshold.
Use the no or default form of this command to restore the default setting.
arp-guard scan-threshold pkt-cnt
no arp-guard scan-threshold
default arp-guard scan-threshold
Parameter
Description
Parameter
Description
pkt-cnt
Sets the scan threshold, in the range from 1 to 19,999 in the unit of
seconds.
Defaults
The default value varies with products. For details, see the Configuration Guide.
Command
Mode
NFPP configuration mode
Usage Guide
The scanning may occur on the condition that:
 More than 15 packets are received within 10 seconds;
 The source MAC address for the link layer is constant while the source IP address is uncertain;
 The source MAC and IP address for the link layer is constant while the destination IP address is
uncertain.