Configuration Guide NFPP Commands
cpu-protect sub-interface { manage | protocol |
route } pps
Configures the traffic bandwidth of each type of
packets.
21.20 cpu-protect sub-interface { manage | protocol | route } pps
Use this command to configure the traffic bandwidth of each type of packets.
Use the no or default form of this command to restore the default setting.
cpu-protect sub-interface { manage | protocol | route } pps pps_vaule
no cpu-protect sub-interface { manage | protocol | route } pps
default cpu-protect sub-interface { manage | protocol | route } pps
The rate limit threshold, in the range from 1 to 100,000
The default value varies with products. For details, see the Configuration Guide.
Global configuration mode
The following example sets the traffic bandwidth of management packets to 2,000 pps.
Ruijie(config)# cpu-protect sub-interface manage pps 2000
cpu-protect sub-interface { manage | protocol |
route } percent
Configures the percent value of each type of
packets occupied in the buffer area.
Use this command to define the anti-attack type.
To Next Page
Loading...
