Ruijie RG-S29 Series - Page 1281

Configuration Guide NFPP Commands
Status
Enables/Disables the anti-attack function.
Rate-limit
In the format of the rate-limit threshold for the
NS-NA/RS/RA-REDIRECT.
Attack-threshold
In the same format as the rate-limit.
Related
Commands
Command
Description
nd-guard attack-threshold
Sets the global attack threshold.
nd-guard enable
Enables the ND anti-attack function.
nd-guard rate-limit
Sets the global rate-limit threshold.
nfpp nd-guard enable
Enables the ND anti-attack function on the
interface.
nfpp nd-guard policy
Sets the rate-limit threshold and attack
threshold.
Platform
Description
N/A
21.99 show nfpp nd-guard hosts
Use this command to display the monitored host.
show nfpp nd-guard hosts [statistics | [[vlan vid] [interface interface-id]]]
Parameter
Description
Parameter
Description
statistics
Displays the statistics of the monitored host.
vid
Sets the VLAN ID.
interface-id
Sets the interface name and number.
Command
Mode
Privileged EXEC mode
Usage Guide
N/A
Configuration
Examples
The following example displays the statistics of the host monitored by ND-guard.
Ruijie#show nfpp nd-guard hosts statistics
success fail total
------- ---- -----
10 2 12
The following example displays the host monitored by ND-guard. The “remain-time(s)” refers to the
remaining time of isolation.
Ruijie#show nfpp nd-guard hosts
If col_filter 1 shows '*', it means "hardware do not isolate host".