Command Reference QoS Commands
rate limit input Kbps = 10240 burst = 256
Interface: GigabitEthernet 0/3
rate limit output Kbps = 102400 burst = 4096
The fields in the output of this command are described in the following table.
Indicates the interface name.
rate limit input Kbps = x burst = y
Indicates the input rate limit value, and the input
burst traffic limit value.
rate limit output Kbps = x burst = y
Indicates the output rate limit value, and the
output burst traffic limit value.
2.24 show mls qos scheduler
Use this command to display the queue scheduling policy.
show mls qos scheduler [ interface interface-id ]
Privileged EXEC mode, global configuration mode, interface configuration mode.
The following example displays the queue scheduling policy.
Ruijie# show mls qos scheduler
Global Multi-Layer Switching scheduling
Weighted Round Robin
The fields in the output of this command are described in the following table.
Indicates that the queue scheduling policy is
To Next Page
Loading...
Need help?
General