Command Reference QoS Commands
The fields in the output of this command are described in the following table.
Indicates the virtual group number.
Indicates the member port in the virtual group.
Use this command to create a virtual group in global configuration mode.
Use this command to configure add an interface to a virtual group in interface configuration mode.
Use the no or default form of this command to remove a virtual group in global configuration mode.
Use the no or default form of this command to remove an interface from a virtual group in interface
configuration mode.
virtual-group virtual-group-number
no virtual-group virtual-group-number
default virtual-group virtual-group-number
Virtual group number. The range is from 1 to 128.
No virtual group is configured, or no interface is added to a virtual group, by default.
Interface configuration mode, global configuration mode.
The member port added to the virtual group must be a physical port or an aggregate port member.
The following example sets the interface gigabitEthernet 1/3 as the member of virtual group 3:
Ruijie(config)# interface gigabitethernet 1/3
Ruijie(config-if)# virtual-group 3
show virtual-group [ virtual-group-number |
summary ]
Displays the virtual group configuration.
To Next Page
Loading...
