Command Reference QoS Commands
Use this command to configure the WFQ queue weight ratio. Use the no or default form of this
command to restore the default setting.
wfq-queue bandwidth weight1 ... weight8
default wfq-queue bandwidth
8 queue weights. The default queue weight ratio is 1:1:1:1:1:1:1:1.
For the products supporting the SP scheduling policy, the weight
range is from 0 to 15.
For the products not supporting the SP scheduling policy, the weight
range is from 1 to 15.
The default queue weight ratio is 1:1:1:1:1:1:1:1.
Global configuration mode.
If the weight value is 0, the SP scheduling policy is applied.
The following example configures the WFQ queue weight ratio to 1:1:2:4:4:4:6:8.
Ruijie(config)# wfq-queue bandwidth 1 1 2 4 4 4 6 8
Displays the QoS queuing configuration.
Use this command to set the WRR weight ratio. Use the no or default form of this command to
restore the default setting.
wrr-queue bandwidth weight1 ... weight8
To Next Page
Loading...
Need help?
General