Ruijie RG-S29 Series

Command Reference REUP Commands
no link state track [ num ]
Parameter
Description
Parameter
Description
num
Interface ID of the link aggregation group.
Defaults
N/A.
Command
Mode
Global configuration mode.
Usage Guide
First create a link state track group and then add a port into the specified link state track group.
Configuration
Examples
The following example shows how to create a link state track group:
Ruijie(config)# link state track 1
Related
Commands
Command
Description
link state group
Adds the port to the specified link state track
group.
Platform
Description
N/A.
1.3 mac-address-table move update max-update-rate
Use this command to configure the maximum number of MAC address update packets sent per
second.
mac-address-table move update max-update-rate pkts-per-second
no mac-address-table move update max-update-rate
Parameter
Description
Parameter
Description
pkts-per-second
The maximum number of MAC address update packets sent per
second. It ranges from 0 to 32000, and the default value is 150.
Defaults
A maximum of 150 MAC address update packets are sent per second.
Command
Mode
Global configuration mode.
Usage Guide
When a link is switched, REUP sends a certain number of MAC address update packets to an uplink
device in every second to recover downlink data transmission of the uplink device.