Command Reference REUP Commands
The following example shows how to configure the maximum number of MAC address update
packets sent per second:
Ruijie(config)# mac-address-table move update max-update-rate 20
1.4 mac-address-table move update receive
Use this command to enable REUP to receive the mac-address-table update messages.
mac-address-table move update receive
no mac-address-table move update receive
Global configuration mode.
The dual link backup switchover will lead to the loss of downstream data flow, for the MAC address
for the uplink switch has not been updated in time. Therefore, it is necessary to update the MAC
address table of the uplink switch, to reduce the loss of L2 data flow. You need to enable the switch of
receiving the MAC address update messages on the uplink switch.
Ruijie(config)# mac-address-table move update receive
mac-address-table move update transit
Enables REUP to transmit the
mac-address-table update messages.
To Next Page
Loading...
Need help?
General