Ruijie RG-S29 Series

Command Reference REUP Commands
1.5 mac-address-table move update receive vlan
Use this command to configure the VLANs processing MAC address update packets.
mac-address-table move update receive vlan vlan-range
no mac-address-table move update receive vlan vlan-range
Parameter
Description
Parameter
Description
vlan-range
Range of the VLANs processing MAC address update packets.
Defaults
All VLANs process MAC address update packets.
Command
Mode
Global configuration mode.
Usage Guide
This command can be used to disable some VLANs from processing MAC address update packets.
VLANs disabled from processing MAC address update packets can still recover downlink data
transmission of the uplink device using MAC address update packets, but the capability to provide
convergence on link failure will be degraded.
Configuration
Examples
The following example configures VLANs processing MAC address update packets:
Ruijie(config)# no mac-address-table move update receive vlan 20
Related
Commands
Command
Description
mac-address-table move update receive
Enables REUP to receive MAC address update
packets.
Platform
Description
N/A.
1.6 mac-address-table move update transit
Use this command to enable REUP to transmit the mac-address-table update messages.
mac-address-table move update transit
no mac-address-table move update transit
Parameter
Description
Parameter
Description
N/A.
N/A.
Defaults
Disabled.