Ruijie RG-S29 Series

Command Reference REUP Commands
Command
Mode
Global configuration mode.
Usage Guide
In order to reduce the link switchover and the loss of the downstream data flow, it is necessary to
enable the switch of receiving the MAC address update messages on the uplink switch.
Configuration
Examples
Ruijie(config)# mac-address-table move update transit
Related
Commands
Command
Description
mac-address-table move update transit vlan
Enables REUP to transmit the
mac-address-table update messages.
Platform
Description
N/A.
1.7 mac-address-table move update transit vlan
Use this command to enable REUP to transmit the mac-address update messages.
mac-address-table move update transit vlan vid
no mac-address-table move update transit vlan
Parameter
Description
Parameter
Description
vid
ID of the VLAN transmitting MAC address update packets.
Defaults
Transmit the MAC-address update messages in the default VLAN on the port.
Command
Mode
Interface configuration mode.
Usage Guide
When a link is switched, the VLAN enabled to transmit MAC address update packets will send MAC
address update packets to its uplink device.
Configuration
Examples
The following example configures VLANs transmitting MAC address update packets:
Ruijie(config)# mac-address-table move update transit
Related
Commands
Command
Description
mac-address-table move update transit
Enables REUP to receive the
mac-address-table update messages.
Platform
N/A.