Command Reference REUP Commands
1.8 mac-address-table update group
Use this command to set the mac-address-table update group.
mac-address-table update group [ group-num ]
no mac-address-table update group
The mac-address-table update group ID.
By default, no mac-address-table update group is configured.
Interface configuration mode.
In order to reduce the flood due to the MAC address update and the influence on the normal data
transmission of the switch, Ruijie products add a configuration of MAC address update group. Only if
all the interfaces are added to a MAC address update group, the downstream data transmission be
restored rapidly.
Ruijie(config-if)# mac-address-table update group 2
show mac-address-table update group detail
Displays the mac-address-table update group
information.
1.9 show interfaces switchport backup
Use this command to display the dual link backup information on the interfaces.
show interfaces [ interface-id ] switchport backup [ detail ]
The interface id of the dual link backup.
Displays the detailed information about the dual link backup.
To Next Page
Loading...
Need help?
General