Command Reference RLDP Commands
2 RLDP Commands
2.1 rldp detect-interval
Use this command to configure the interval at which the RLDP sends the detection message on the
port. Use the no form of this command to restore the default value.
rldp detect-interval interval
Detection interval in the range 2 to 15 seconds
Global configuration mode.
In the environment where STP is enabled, it is recommended that the product of interval multiplying
the maximum number of detections is less than the topology convergence time of STP.
The following example shows how to set the detection interval as 5s:
Ruijie(config)# rldp detect-interval 5
Sets the maximum number of detections.
Use this command to set the maximum number of sending detection packets on the port. If the
neighboring port does not respond when this detection number is exceeded, the link is considered
faulty. Use the no form of this command to restore it to the default value.
To Next Page
Loading...
