Command Reference RLDP Commands
Maximum number of detections in the range 2 to 10
Global configuration mode.
This command is used together with the detection interval to specify the maximum number of
detections.
The following example shows how to set the maximum number of detections as 5:
Ruijie(config)# rldp detect-max 5
Sets the detection interval.
Use this command to enable RLDP globally. Use the no form of this command to disable the function.
Global configuration mode.
You can enable RLDP on the interface only when the global RLDP is enabled.
The following example shows how to enable RLDP:
Ruijie(config)# rldp enable
Enables the RLDP function on the port.
To Next Page
Loading...
Need help?
General