Command Reference RLDP Commands
2.4 rldp neighbor-negotiation
Use this command to enable RLDP neighbor negotiation. Use the no form or default form of this
command to restore the default setting.
rldp neighbor-negotiation
no rldp neighbor-negotiation
default rldp neighbor-negotiation
RLDP neighbor negotiation is disabled by default.
Global configuration mode.
With neighbor negotiation enabled, RLDP unidirectional-/bidirectional-link detection starts only after
the neighbor negotiation is successful. (Receiving the Prob message from the neighbor indicates the
neighbor negotiation is successful.)
The following example shows how to enable RLDP neighbor negotiation:
Ruijie#config
Ruijie(config)#rldp neighbor-negotiation
Enables the RLDP function on the port.
Use this command to enable RLDP on the port and specify detection type and troubleshooting
method. Use the no form of this command to disable the function.
rldp port { unidirection-detect | bidirection-detect | loop-detect } { warning | shutdown-svi |
shutdown-port | block }
no rldp port { unidirection-detect | bidirection-detect | loop-detect }
To Next Page
Loading...
Need help?
General