Command Reference RLDP Commands
Sets unidirectional link detection.
Sets bidirectional link detection.
Sets loop detection type.
Shutdowns the SVI the port belongs to.
Interface configuration mode.
The RLDP detection on the port takes effect only when the global RLDP is enabled.
The following example shows how to configure RLDP detection on fas 0/1, specify the detection type
as loop detection, and troubleshooting method as block.
Ruijie(config)# interface fas 0/1
Ruijie(config-if)# rldp port loop-detect block
Use this command to make all the ports that have been handled using rldp shutdown or disable to
perform RLDP detection again.
To Next Page
Loading...
Need help?
General