Command Reference Time Range Commands
Displays a specified time range.
Use this command to check the time range configuration.
The following example displays the time range configuration.
Ruijie# show time-range
time-range entry: test (inactive)
absolute end 01:02 02 February 2012
Use this command to create a time range and enter time range configuration mode.
time-range time-range-name
Use the no form of this command to remove the configured time range.
no time-range time-range-name
No time range is configured by default.
Global configuration mode
Some applications (such as ACL ) may run based on time. For example, an ACL can be effective within
certain time ranges of a week. To this end, first you must configure a time range. After the time range is
To Next Page
Loading...
Need help?
General