Ruijie RG-S29 Series

Command Reference VSU Commands
Examples
Ruijie(config)# interface GigabitEthernet 1/0/3
Ruijie(config-if- GigabitEthernet 1/0/3)# no switchport
Ruijie(config)# switch virtual domain 1
Ruijie(config-vs-domain)# dual-active exclude interface GigabitEthernet
1/0/3
Related
Commands
Command
Description
dual-active detection
Configures DAD.
dual-active pair interface
Configures a DAD interface.
show switch virtual dual-active
Displays the configuration and status of DAD.
Platform
Description
N/A
7.5 dual-active interface
Use this command to configure an AP-based DAD interface.
Use the no form of this command to remove the setting.
dual-active interface interface-name
no dual-active interface
Parameter
Description
Parameter
Description
interface-name
Interface type and interface number. An AP-based DAD
interface must be specified.
Defaults
N/A
Command Mode
config-vs-domain configuration mode
Usage Guide
Only one AP-based detection interface can be configured. Create an AP-based interface before
setting it to a detection interface. The previous detection interface will be overwritten by the
current detection interface.
Configuration
Examples
The following example configures AP 1 as the AP-based detection interface.
Ruijie(config)# interface aggregateport 1
Ruijie(config-if-AggregatePort 1)#exit
Ruijie(config)# switch virtual domain 1
Ruijie(config-vs-domain)# dual-active interface aggregateport 1
Related
Commands
Command
Description
dual-active detection
Configures BFD-/AP-based DAD.
show switch virtual dual-active
Displays the configuration and status of DAD.