Ruijie RG-S29 Series User Manual

Command Reference VSU Commands
Switch[-]
Device description.
Related
Commands
Command
Description
N/A
N/A
Platform
Description
N/A
7.15 switch
Use this command to specify the ID of a device in the VSU system.
Use the no form of this command to restore the default setting.
switch switch_id
no switch
Parameter
Description
Parameter
Description
switch_id
ID of a device in the VSU system
The range depends on products.
Defaults
The default is 1.
Command Mode
config-vs-domain configuration mode
Usage Guide
The device ID identifies each virtual device member. In VSU mode, the interface name format
changes to "switch/slot/port" from "slot/port", in which "switch" is the device ID.
If either chassis are active or if the role of the just started chassis is uncertain and both have the
same priority, the chassis with a smaller ID is elected as the active one.
This command can be only used to modify the device ID in standalone mode. In VSU mode, run
the switch renumber command to modify the device ID. The modified device ID takes effect only
after you restart the device, regardless of in standalone mode or in VSU mode.
Configuration
Examples
The following example sets the ID of the device whose domain ID is 1 to 2 in the VSU system.
Ruijie(config)# switch virtual domain 1
Ruijie(config-vs-domain)# switch 2
Ruijie(config-vs-domain)# exit
Related
Commands
Command
Description
switch virtual domain
Modifies the domain ID of a device in standalone mode.
switch priority
Configures the priority of a device in the VSU system.
show switch virtual
Displays the domain ID as well as the ID and role of each
chassis.
Platform
N/A

Ruijie RG-S29 Series Specifications

General

Brand	Ruijie
Model	RG-S29 Series
Category	Switch
Language	English