Ruijie RG-S29 Series

Command Reference SNMP Commands
disable the interface to send link traps.
snmp trap link-status
no snmp trap link-status
Parameter
Description
Parameter
Description
N/A
N/A
Defaults
Sending link traps on the interface is enabled by default. If the interface link status changes, SNMP
link traps will be sent.
Command
mode
Interface configuration mode
Usage Guide
This command can be configured on the Ethernet interface, aggregate ports and SVI interfaces.
Configuration
Examples
The following example disables the interface to send link traps.
Ruijie(config)# interface gigabitEthernet 1/1
Ruijie(config-if–GigabitEthernet 1/1)# no snmp trap link-status
The following example enables the interface to send link traps.
Ruijie(config)# interface gigabitEthernet 1/1
Ruijie(config-if–GigabitEthernet 1/1)# snmp trap link-status
Related
Commands
Command
Description
N/A
N/A
Platform
Description
N/A
1.4 snmp-server chassis-id
Use this command to specify the SNMP chassis ID. Use the no form of this command to restore the
default chassis ID.
snmp-server chassis-id text
no snmp-server chassis-id
Parameter
Description
Parameter
Description
text
SNMP chassis ID: numerals or characters.
Defaults
The default is 60FF60.