Command Reference Basic Configuration Management Commands
Global configuration mode
The system discards all the characters next to the terminating symbol.
When authentication times out, the banner prompt-timeout message is displayed.
The following example configures the prompt-timeout message to notify timeout.
Ruijie(config)# banner exec $ authentication timeout $
Use this command to configure the slip-ppp message for the SLIP/PPP session. Use the no form of
this command to remove the setting.
banner slip-ppp c message c
Separator of the message. Delimiters are not allowed in the
message.
Global configuration mode
This command is used to configure the slip-ppp message for the SLIP/PPP session. The system
discards all the characters next to the terminating symbol.
When the SLIP/PPP session is created, the slip-ppp message is displayed on the corresponding
terminal.
To Next Page
Loading...
Need help?
General