Command Reference Syslog Commands
Whether the logging function is enabled or disabled.
The level and statistics of the log message printed on
the console.
The level and statistics of the log message printed on
the VTY window.
The level and statistics of the log message recorded in
the memory buffer.
Timestamp format of debugging message.
Timestamp format of log message.
Sequence-number log messages
Whether the sequence number function is enabled or
disabled.
Adds the system name to the log message.
The level and statistics of the log message sent to the
syslog server.
The following example displays the outcome of running the show logging config command with
RFC5424 enabled.
Ruijie# show logging
Syslog logging: enabled
Console logging: level debugging, 4740 messages logged
Monitor logging: level debugging, 0 messages logged
Buffer logging: level debugging, 4745 messages logged
Statistic log messages: disable
Statistic log messages to terminal: disable
Delay-send file name:syslog_ftp_server, Current write index:3, Current send
index:3, Cycle:10 seconds
Count log messages: enable
Trap logging: level informational, 2641 message lines logged,4155 fail
logging to 192.168.23.89
logging to 2000::1
Delay-send logging: 2641 message lines logged
logging to 192.168.23.89 by tftp
Logging flag: enabled or disabled
Level of the logs printed on the console, and statistics
Level of the logs printed on the VTY window, and
statistics
Level of the logs recorded in the memory buffer, and
statistics.
Enables/disables log sending periodically
To Next Page
Loading...
Need help?
General