Command Reference PKG_MGMT Commands
This command is used to upgrade an installation package on the
device.
This command is applicable to installation packages of all subsystem components, chassis devices,
and feature components. Before its use, run the copy command to copy feature packages into the file
system in the device.
When there is no specified range of parameters, the command is used to upgrade the matched
system components according to the auto-sync configuration.
Run the show version detail command to check whether the upgrade of a subsystem component is
successful.
Run the show component command to check whether the upgrade of a feature component is
successful. upgrading a feature component
The prompt message of successful running is displayed.
Upgrade info [OK]
The installation package is invalid or damaged and needs to be regained for upgrade command.
Invalid package file
The installation package is not available on the device and needs to be regained for upgrade
command.
Device don't support
There is no need to upgrade the device.
The version in device is newer or the same
When there is insufficient space for upgrade, check USB flash disk attached on the device.
No enough space for decompress
Contact the service center to solve the system problem.
No enough space,rootfs been destroyed. Please upgrade in uboot
To Next Page
Loading...
Need help?
General