Ruijie RG-S29 Series

Command Reference PKG_MGMT Commands
Mode
Default Level
2
Usage Guide
Check whether the upgrade package is ready before using the command.
Configuration
Examples
The following example sets the auto-sync policy of the device based on the version of supervisor
modules.
Ruijie# upgrade auto-sync policy coordinate
Verification
Display the current policy for auto-sync upgrade by running the show upgrade auto-sync command.
Prompt
Messages
The prompt message of successful running is displayed.
Upgrade auto-sync policy is set as coordinate.
15.9 upgrade auto-sync range
Use this command to set the range of auto-sync upgrade.
upgrade auto-sync range [ chassis | vsu ]
Parameter
Description
Parameter
Description
chassis
Auto-sync version upgrade in the range of chassis
vsu
Auto-sync version upgrade in the range of the VSU system.
Defaults
vsu
Command
Mode
Privileged EXEC mode
Default Level
2
Usage Guide
It is recommended to set the parameter to vsu to ensure system version consistency to the most
extent.
Configuration
Examples
The following example installs the auto-sync upgrade in the VSU system.
Ruijie# upgrade auto-sync range vsu
Verification
Run the show upgrade auto-sync command to display the range of current auto-sync upgrade.
Prompt
Messages
The prompt message of successful running is displayed.
Upgrade auto-sync range is set as vsu.