end Exit from interface configuration mode
exit Exit from interface configuration mode
expert Expert extended ACL
flowcontrol Set the flow-control value for an interface
full-duplex Force full duplex operation
global Global ACL
gvrp GVRP configure command
half-duplex Force half duplex operation
help Description of the interactive help system
ip Interface Internet Protocol config commands
ipv6 Internet Protocol Version 6
isis Intermediate System - Intermediate System (IS-IS)
l2 Config L2 attribute
label-switching Enable interface process mpls packet
lacp LACP interface subcommands
lldp Link Layer Discovery Protocol
load-interval Specify interval for load calculation for an interface
mac Mac extended ACL
mac-address Set mac-address
mpls Multi-Protocol Label Switching
mtu Set the interface Maximum Transmission Unit (MTU)
no Negate a command or set its defaults
ntp Configure NTP
port-group Aggregateport/port bundling configuration
redirect Redirect packets
rmon Rmon command
security Configure the Security
show Show running system information
shutdown Shutdown the selected interface
snmp Modify SNMP interface parameters
speed Configure speed operation
switchport Set switching mode characteristics
vrf Multi-af VPN Routing/Forwarding parameters on the interface
vrrp VRRP interface subcommands
xconnect Xconnect commands
The following example displays the parameters of a specified command.
Ruijie(config)#access-list 1 permit ?
A.B.C.D Source address
any Any source host
host A single source host
To Next Page
Loading...
Need help?
General