Command Reference Basic Configuration Management Commands
Use this command to specify or modify the hostname of a device.
Device hostname, string, number or hyphen, up to 63 characters.
Global configuration mode
This hostname is mainly used to identify the device and is taken as the username for the local device
during dialup and CHAP authentication.
The following example configures the hostname of the device as BeiJingAgenda.
Ruijie(config)# hostname BeiJingAgenda
BeiJingAgenda(config)#
2.24 ip telnet source-interface
Use this command to configure the IP address of an interface as the source address for Telnet
connection.
ip telnet source-interface interface-name
Configures the IP address of the interface, including AP port, Gi port,
Loopback port, null port, Tunnel port and VLAN port, as the source
address for Telnet connection.
To Next Page
Loading...
Need help?
General