Ruijie RG-S29 Series

Command Reference Basic Configuration Management Commands
Defaults
N/A
Command
Mode
Global configuration mode
Usage Guide
This command is used to specify the IP address of an interface as the source address for global
Telnet connetction. When using the telnet command to log in a Telnet server, apply the global setting
if no source interface or source address is specified. Use the no ip telnet source-interface
command to restore it to the default setting.
Configuration
Examples
The following example configures the IP address of the Loopback1 interface as the source address
for global Telnet connection.
Ruijie(Config)# ip telnet source-interface Loopback 1
Related
Commands
Command
Description
telnet
Logs in a Telnet server.
Platform
Description
N/A
2.25 lock
Use this command to set a temporary password for the terminal.
lock
Parameter
Description
Parameter
Description
N/A
N/A
Defaults
N/A
Command
Mode
User EXEC mode
Usage Guide
You can lock the terminal interface and maintain the session continuity to prevent access to the
interface by setting a temporary password. Take the following steps to lock the terminal interface:
 Enter the lock command, and the system will prompt you for a password:
 Enter the password, which can be any character string. The system will prompt you to confirm
the password, clear the screen, and display the "Locked" information.
 To access the terminal, enter the preset temporary password.
 To lock the terminal, run the lockable command in line configuration mode and enable terminal
locking in the corresponding line.