Command Reference Aggregate Port Commands
You can run aggregateport load-balance in interface configuration mode of an AP port on devices
that support load balancing configuration on a specific AP port. The configuration in interface
configuration mode prevails. To disable the load balancing algorithm, run no aggregateport
load-balance in interface configuration mode of the AP port. After that, the load balancing algorithm
configured in global configuration mode takes effect.
The following example configures a load-balance algorithm globally based on the destination MAC
address.
Ruijie(config)# aggregateport load-balance dst-mac
show aggregateport load-balance
Displays aggregate port configuration.
3.2 aggregateport member linktrap
Use this command to send LinkTrap to aggregate port members. Use the no form of this command to
restore the default setting.
aggregateport member linktrap
no aggregateport member linktrap
This function is disabled by default.
Global configuration mode
This function cannot be enabled by running the snmp trap link-status command in interface
configuration mode. However, it can be enabled by running the aggregateport member linktrap
command in global configuration mode.
The following example enables the LinkTrap function on the aggregate port members.
Ruijie# configure terminal
Ruijie(config)# aggregateport member linktrap
To Next Page
Loading...
Need help?
General