Command Reference Aggregate Port Commands
3.3 aggregateport member minimum
Use this command to set the minimum number of AP member ports. Use the no form of this
command to restore the default setting.
aggregateport member minimum number
no aggregateport member minimum number
Use this command to set actions for the minimum AP member ports. Use the no form of this
command to restore the default setting.
aggregateport member minimum action {shutdown}
The minimum number of AP member ports
Shutdown AP to enable action.
The default is 1. And no action is set.
Interface configuration mode
Optional. For static AP, its peer end also has to apply the function.
The following example sets the minimum number of AP member ports to 2.
Ruijie(config)# interface GigabitEthernet 0/1
Ruijie(config-if-GigabitEthernet 0/1)# port-group 1 mode active
Ruijie(config-if-GigabitEthernet 0/1)# aggregateport minimum member 2
Ruijie(config-if-GigabitEthernet 0/1)# end
Ruijie# show interface aggregateport 1
…
Aggregate Port Informations:
Aggregate Number: 1
Name: "AggregatePort 1"
Members: (count=1) GigabitEthernet 0/1 Link Status: Up Lacp
Status: susp …
To Next Page
Loading...
Need help?
General