Command Reference Aggregate Port Commands
3.4 interfaces aggregateport
Use this command to create the aggregate port or enter interface configuration mode of the
aggregate port. Use the no form of this command to restore the default setting.
interfaces aggregateport ap-number
no interfaces aggregateport ap-number
The aggregate port is not created by default.
Global configuration mode
If the aggregate port is created, this command is used to enter the interface configuration mode.
Otherwise, this command is used to create the aggregate port and then enter its interface
configuration mode.
The following example creates AP 5 and enters its interface configuration mode.
Ruijie# configure terminal
Ruijie(config)# interfaces aggregateport 5
Ruijie(config-if-Aggregateport 5)# end
Use this command to set the priority of the LACP AP member port. Use the no form of this command
to restore the default setting.
lacp port-priority port-priority
The LACP port priority, in the range from 0 to 65535.
To Next Page
Loading...
Need help?
General