Ruijie RG-S29 Series

Command Reference Aggregate Port Commands
N/A
N/A
Platform
Description
N/A
3.7 lacp system-priority
Use this command to set the LACP system priority. Use the no form of this command to restore the
default setting.
lacp system-priority system-priority
no lacp system-priority
Parameter
Description
Parameter
Description
system-priority
The LACP system priority, in the range from 0 to 65535.
Defaults
The default is 32768.
Command
Mode
Global configuration mode.
Usage Guide
Configuration
Examples
The following example sets the LACP system priority to 4096.
Ruijie(config)# lacp system-priority 4096
Related
Commands
Command
Description
port-group key mode { active | passive }
Enables the LACP on the port and specifies the
aggregation group ID and operation mode.
lacp port-priority
Sets the LACP port priority.
Platform
Description
N/A
3.8 port-group
Use this command to assign a physical interface to be a member port of a static aggregate port or an
LACP aggregate port. Use the no form of this command to restore the default setting.
port-group port-group-number
port-group key-number mode { active | passive }
no port-group