Ruijie RG-S29 Series

Command Reference Aggregate Port Commands
Defaults
N/A
Command
Mode
Any mode
Usage Guide
If the aggregate port number is not specified, all the aggregate port information will be displayed.
Configuration
Examples
The following example displays the aggregate port configuration.
Ruijie# show aggregateport 1 summary
AggregatePort MaxPorts SwitchPort Mode Load balance Ports
------------- --------------- ---------- ------ ----------------------------
------------------------
Ag1 8 Enabled ACCESS dst-mac Gi0/2
Related
Commands
Command
Description
aggregateport load-balance
Configures a load-balance algorithm of AP.
Platform
Description
N/A
3.10 show lacp summary
Use this command to display the LACP aggregation information.
show lacp summary [ key ]
Parameter
Description
Parameter
Description
key
Specifies the aggregation group id to show. If it is not specified, all
aggregation group information is displayed by default.
Defaults
N/A
Command
Mode
Any mode.
Usage Guide
N/A
Configuration
Examples
The following example displays the LACP aggregation information.
Ruijie(config)# show lacp summary 3
System Id:32768, 00d0.f8fb.0002
Flags: S - Device is requesting Slow LACPDUs
F - Device is requesting Fast LACPDUs.
A - Device is in active mode. P - Device is in passive mode.
Aggregate port 3: