Command Reference Protocol VLAN Commands
IP address in the x.x.x.x format.
VLAN ID, the maximal VLAN the product supports
It is disabled by default.
Global configuration mode.
The following example configures VLAN 100 for the specified subnet.
Ruijie(config)# protocol-vlan ipv4 192.168.100.3 mask 255. 255.255.0 vlan 100
no protocol-vlan ipv4 addr mask addr
6.3 protocol-vlan profile (in interface configuration mode)
Use this command to apply some profile to an interface.
protocol-vlan profile num vlan id
Use this command to clear the specified profile on the port.
no protocol-vlan profile id
Use this command to clear all profiles on the port.
VLAN ID, the maximal VLAN the product supports.
This function is disabled by default.
To Next Page
Loading...
Need help?
General