Command Reference Protocol VLAN Commands
The interface must be in Trunk or Hybrid mode.
The following example applies profile 1 to VLAN 101.
Ruijie(config-if)# protocol-vlan profile 1 vlan 101
show protocol-vlan profile
show protocol-vlan profile num
no protocol-vlan profile num
6.4 protocol-vlan profile (in global configuration mode)
Use this command to configure the profile for the VLAN.
protocol-vlan profile num frame-type type ether-type type
protocol-vlan profile num frame-type LLC DSAP value SSAP value
Use this command to delete the specified profile.
no protocol-vlan profile num
Use this command to delete all profiles.
Type of message and Ethernet
Service access point type.
It is disabled by default.
Global configuration mode.
The following example configures the profile for the VLAN.
Ruijie(config)# protocol-vlan profile 1 frame-type ETHERII ether-type aarp
Ruijie(config)# protocol-vlan profile 2 frame-type LLC DSAP 255 SSAP 255