Command Reference Basic Configuration Management Commands
Ruijie>enable 10
Password:
Ruijie#
*Sep 10 11:34:20: %SYS-5-PRIV_AUTH_SUCCESS: Authentication to
privilege level 10 from console success
Use this command to enable display of the MOTD message on a specified line. Use the no form of
this command to restore the default setting.
The MOTD message is displayed on all lines by default.
After you configure the banner exec and the banner motd commands, the EXEC and the MOTD
messages are displayed on all lines by default. If you want to disable display of the EXEC and the
MOTD messages on a specific line, configure the no form of this command on the line.
This command does not work for the incoming message. If you configure the banner incoming
command, the banner incoming message is displayed on all reverse Telnet sessions and the
display cannot be disabled on a specific line.
The following example disables display of the MOTD message on VTY 1.
Ruijie(config)# line vty 1
Ruijie(config-line)no motd-banner
To Next Page
Loading...
Need help?
General