Ruijie RG-S29 Series

Command Reference MSTP Commands
from 1 to 10 in the unit of seconds. The default is 2.
max-age seconds
Maximum aging time of the BPDU message, in the range from 6 to 40
in the unit of seconds. The default is 20.
Defaults
This function is disabled by default.
Command
Mode
Global configuration mode.
Usage Guide
The values of forward-time, hello time and max-age are interrelated. Modifying one of these three
parameters will affect the others. There is a restricted relationship among the above three values.
2*(Hello Time+1.0snd) <= Max-Age Time <= 2*(Forward-Delay–1.0snd)
If the values do not according with the condition, the settings do not work.
Configuration
Examples
The following example enables the spanning-tree function.
Ruijie(config)# spanning-tree
The following example configures the BridgeForwardDelay.
Ruijie(config)# spanning-tree forward-time 10
Related
Commands
Command
Description
show spanning-tree
Displays the global STP configuration.
spanning-tree mst cost
Sets the PathCost of an STP interface.
spanning-tree tx-hold-count
Sets the global TxHoldCount of STP.
Platform
Description
N/A
9.18 spanning-tree autoedge
Use this command to enable Autoedge on the interface. Use the disabled form of this command to
disable this function.
spanning-tree autoedge [ disabled ]
Parameter
Description
Parameter
Description
disabled
Disabled Autoedge on the interface.
Defaults
This function is enabled by default.
Command
Mode
Interface configuration mode.