Command Reference MSTP Commands
Global configuration mode.
However, some vendors' devices do not work according to 802.1 protocol standards, possibly
causing incompatibility. If other vendors' devices are incompatible with Ruijie devices, run this
command to switch the STP mode to a lower version.
The following example sets the STP version.
Ruijie(config)# spanning-tree mode stp
Displays the spanning-tree configuration.
9.30 spanning-tree mst configuration
Use this command to enter the MST configuration mode in the global configuration mode and
configure the MSTP region. Use the no form of the command to restore the default setting.
spanning-tree mst configuration
no spanning-tree mst configuration
Global configuration mode.
To return to the privileged EXEC mode, enter end or Ctrl+C.
To return to the global configuration mode, enter exit.
After entering the MST configuration mode, you can configure MSTP Region parameters:
This example enters the MST configuration mode.
Ruijie(config)# spanning-tree mst configuration
Ruijie(config-mst)# instance 1 vlan 3, 5-10
To Next Page
Loading...
Need help?
General