Command Reference MSTP Commands
Disables the portfast on the interface.
This function is disabled by default.
Interface configuration mode.
After PortFast is enabled on a port, the port directly enters the forwarding state. However, since the
Port Fast Operational State becomes disabled due to receipt of BPDUs, the port can properly run the
STP algorithm and enter the forwarding state.
The following example enables the portfast on the interface.
Ruijie(config)# interface gigabitethernet 1/1
Ruijie(config-if-interface-id)# spanning-tree portfast
show spanning-tree interface
Displays the STP configuration of the interface.
9.36 spanning-tree portfast bpdufilter default
Use this command to enable the BPDU filter function globally. You can use the no form of the
command to restore the default setting.
spanning-tree portfast bpdufilter default
no spanning-tree portfast bpdufilter default
This function is disabled by default,
Global configuration mode.
Once the BPDU filter is enabled, the BPDU message is neither received nor sent on the Port Fast
interface. Use the show spanning-tree command to display the configuration.
To Next Page
Loading...
Need help?
General